36 Posts
pgtr started a discussion
Would Soffit Vents Rob Airflow From Vents in Lower Shed Walls? - Not exactly HVAC but hopefully related... I'm building a 12 x 10 shed with a ridge vent in a hot summer environment. I was planning on putt... Read More
    3 Comments
pgtr started a discussion
Help with Deere Piranha 44M Deck Please - I am swapping from a 42C to a 44M deck I picked up used recently for my LX tractor. It can be configured two ways: 1) Discharge with DISCHAR... Read More
    1 Comment
pgtr started a discussion
Good Cheap Work Gloves for Tools? - When running a chainsaw, trimming, pulling limbs, working with hand tools like hand saws, shears, etc. - I have terrible luck with gloves. T... Read More
    10 Comments
pgtr started a discussion
Recommendation for Window AC - yet another unit has failed - I bought a 10,000 BTU Amana unit back in the 90s. Worked great for about 12 years in my 400ish SF workshop even in triple digit summers - co... Read More
    1 Comment
pgtr started a discussion
Husqvarna Rubbish Saw Not Cutting Straight... Again. - So after purchasing a brand new Oregon bar and chain my Husqvarna 55 Rubbish saw, in a matter of 30 minutes or so - has returned to cutting ... Read More
    10 Comments
pgtr started a discussion
Chainsaw Mask w/ or w/o Helmet? - I was thinking about putting a chainsaw mask on my xmas list. I normally just wear headphones. Sometimes I get a plastic face shield out of ... Read More
    7 Comments
pgtr started a discussion
Husqv 55: Bar NOT Lubricating - When first operating my rubbish saw, as a check I initially point it at something and run it to see a 'pattern' of oil sling off the tip of ... Read More
    2 Comments
pgtr started a discussion
27 Yr Old Whirlpool Died - looking at SpeedQueen or Whirlpool - I've had my Whirlpool Washer/Dryer since 1984. In recent years had to do a few repairs such as a wigwag etc. But now it's no longer spinning... Read More
    7 Comments
pgtr started a discussion
Bar/Chain Recommendations - I have a Husqvarna 55 rubbish saw, ~2000, 18" bar, 51cc, 2.4kW@9k, used mostly on hardwood in VERY sandy conditions. The original bar/... Read More
    2 Comments
pgtr started a discussion
Quantifiable Differences: Premium vs 'Value' 2-Cycle Engines - Let's assume both are properly set up at the point of sell retailer and receive proper care and feeding during usage by the operator to equa... Read More
    7 Comments
Show More Events...